SAFETY RULES FOR BATTERY USER

 
BULLDOG BATTERY CORPORATION recommends the following safety rules for battery users, If observed, these rules can prevent injury.
 
Wear rubber apron, gloves, boots and goggles when working on batteries
Disconnect the battery from the truck while doing battery repair.
Shut off and disconnect the charger when working on battery charger.
Never lay metal tools on top of the battery.
Always have water available in case of electrolyte splash.
Keep open flames away from storage batteries.
Neutralize acid spills with supply of baking soda or similar alkali.
Always add "acid" to water and stir constantly to mix well.
Melt sealing compound carefully. Do not allow compound to ignite by too rapid heating.
Remove vent caps from near by cells and blow out excess gas when getting ready to repair battery cell when using flame.
When repairing cell, cover the vent holes with layer of damp cloth before using burning torch on intercell connectors.
Lift batteries with approved lifting bar and hoist.
Keep vent plugs in the cells at all times, except when taking hydrometer readings, adjusting gravity and acid levels, trouble shooting or making repairs.
If electrolyte is splashed in the eyes, flush eyes with water from safety fountain or cold water tap and get medical attention immediately.